Limited telnet lines.

[cjt0103]

Sorry, there are already 2 active TCP/IP sessions on this system.

I have it set to allow 256 channels to connect on and open to telnet customers...just dont know where im missing the additional setting to really open the board up to 256 users. Using WG3.2...

Thanks

[Luther]

These are the only two factors that effect those settings that I use.



Make sure it is not in demo mode? If it is in demo, reinstall and put the reg code in. You should be able to tell if its in demo from the initilialze screen.



Hardware Setup



Group 1 :TCP/IP

Starting Channel: 1

Number of Channels: 255



Save and your all set.

[cjt0103]

Bingo Luther!...never even saw that setting. Thanks for the help m8.