Page 1 of 1
Zero users allowed?
Posted: Thu Feb 13, 2003 5:52 am
by MydKnight
When i start up WG it gives a message MajorMUD - 0 users MajorMud Buffers allocated and CNF options verified. When i telnet in, it says the max number of users are online. what gives?
Re: Zero users allowed?
Posted: Thu Feb 13, 2003 7:27 am
by BlackHaze
Bad Reg code.
Re: Zero users allowed?
Posted: Thu Feb 13, 2003 8:13 am
by Speed
Your majormud isn't registered correctly. Copy the correct DLL over to your WG directory. What version of MMud are you using?
If you can't telnet in, that is a seperate WG problem. You probably don't have that registered properly either. Check the WG registration code you got from Galacticomm and re-enter it. If that doesn't work, re-install over the current copy and re-enter it there. After you get everything set up, make sure you go into your hardware setup and allow more than 2 incoming telnet connections.